Robe 250 XT Especificaciones

1

105. DMX protocolChannel Value Function Type of control1 Colour-wheel 0 White/open proportional10 Turquoise proportional21 Red proportional32 Cyan pr

116. AddressingThe Control Board on the rear side of the BEAM 250 XT allows you to assign the DMX fixture address, which isdefined as the first channe

127.4 Effect-wheelThis wheel has both hot and cold color temperature filters (3200 K and 5600 K), UV filter. Cyan, Magenta andyellow filters for color

13[Mode] to return to the main menu. In order to reset the counter to 0, you have to hold the [Up] and [Down]-buttonand press the [Enter]-button.Power

14Lamp On automaticallyThis function enables to switch On the lamp automatically after switching On the fixture. Use the [Up] or [Down]keys to select

15Lamp Off via DMXThis function allows you to switch Off the lamp by DMX. Use the [Up] or [Down]-key to select "On" if you wantto switch Of

16Default settingsPress [Enter] to reset all fixture personalities (not the adjusting functions) to the default values. On the displaywill appear &quo

17in the table mentioned below.DMX Calibration protocol:After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and r

18FrErIt will appear if the frequency of the main is not standard 50 or 60Hz.10. Technical specificationsPower supply: Voltage...

19Colours:- 11 dichroic-filters plus white- Effect-wheel with cyan, magenta and yellow for additive colour-mixing- 2 additional correction-filters for

2

20Weight:10,5 kg11. Maintenance and cleaningIt is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-fluid residues mus

3Table of contents1. Safety instructions... 42.

4CAUTION!Keep this device away from rain and moisture!Unplug mains lead before opening the housing!FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL C

52. Operating determinationsThis device was designed for indoor use only.If the device has been exposed to drastic temperature fluctuation (e.g. afte

63. Description of the deviceControl board1 - Lens2 - Zoom-screw3 - Focus-screw4 - Bracket5 - Bracket-screw6 - Housing7 - Fastening screwsRear panel:

74. Installation4.1Fitting/Exchanging the lampDANGER !Install the lamps with the device switched off only.Unplug from mains before !To insert the lamp

84.3 Inserting/Exchanging the gobosDANGER! Install the gobos with the device switched off only.Unplug from mains before!In order to exchange the gobos

94.6 DMX-512 connection/connection between fixturesThe wires must not come into contact with each other, otherwisethe fixtures will not work at all, o