Robe ROBIN Pointe Especificaciones descargar pdf (Pagina 31)

...Another options for this command (only for Robe´s xtures):

value PARAMETER_DATA=0x84 - lamp OFF by DMX value on DMX channel

value PARAMETER_DATA=0x88 - lamp OFF if DMX is not present

...Commands relative resetable values

8. Error and information messages

Occurred errors during xture operation are signalled by the yellow warning icon at the bottom line of the

screen:

Touch the warning icon or press the [ESCAPE] button to display error messages.

List of error and information messages:

Lamp Error

If the ignition of the lamp is 3 times unsuccessful , the display shows “Lamp Error”, meaning that the lamp could

be damaged or even missed or there could be a failure on the lamp driver.

Overheated

This message informs that the xture had been overheated and the lamp was switched off by means of the

head temperature sensor.

Temper.Sensor Error

The message informs you that the communication betwen the head temperature sensor and the main proces-

sor failed and the lamp has been switched off.

Faulty battery

The battery on the display board is exhausted and should be replaced immediately.

Tilt Error 1 (Tilt Error 2)

This message will appear after the reset of the xture if the head´s magnetic-indexing circuit malfunctions (sen-

sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The head is not

located in the default position after the reset.

Pan Error 1 (Pan Error 2)

This message will appear after the reset of the xture if the yoke´s magnetic-indexing circuit malfunctions (sen-

sor failed or magnet is missing) or the stepping motor is defective or its driving IC on the PCB. The yoke is not

located in the default position after the reset of the xture.

Colour Wheel Error 1(Colour Wheel Error 2)

The messages will appear after the reset of the colour wheel if this wheel is not located in the default posi-

tion.

Dimmer Error 1 (Dimmer Error 2 )

The messages will appear after the reset of the dimmer/strobe module if the strobe lamellas are not located in

the default position.

Strobe 2 Error 1 (Strobe 2 Error 2 )

The messages will appear after the reset of the dimmer/strobe module if the strobe lamella 2 is not located in

the default position.

Prism I Error 1 (Prism I Error 2 )

The messages will appear after the reset of the linear prism wheel if this effect is not located in the default

position.

Prism I Rotation Error 1 (Prism I Rotation Error 2 )

The messages will appear after the reset of the linear prism wheel if this effect is not located in the default

position.

Prism 2 Error 1 (Prism 2 Error 2 )

The messages will appear after the reset of the circular prism wheel if this effect is not located in the default

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Comentarios a estos manuales

Sin comentarios

Robe ROBIN Pointe Especificaciones Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Reflectores Robe ROBIN Pointe